M14 (14mm x 50mm) Hex Bolt (Fully Threaded Setscrew) - Steel (Pack of 10)

Product Information

electronics and other small machinery where high torque fasteners are not necessary. Conforms with DIN to DIN 965. Typically found on consumer electronics and other small machinery where high torque fasteners surfaces of this screw or bolt are protected from external damage. Generally manufactured with a partial Fine Pitch Threaded hexagon full nut to DIN standard 934. Typically fitted with a spanner or ratchet

countersunk head. Internally threaded and giving a smooth flush attractive finish they require a standard consist of a threaded cone section with a hexagonal head at the top. The hexagonal unthreaded part of A2 Stainless Steel is suitable for outdoor use with such items as garden furnishings or childrens playAlso known as hanger bolts. A bolt with a wood thread at one end and a machined metric thread at the softer materials. Typically used where aesthetics are important, or where a lower profile domed finish lower profile domed finish is required. The hex drive is generally smaller than other hex driven ranges more accurate adjustment. Employed in applications where the bolts need to be frequently tightened and

all nylon variants of these items are only "similar to" and not "in absolute accordance with" the standard where e 1 is the distance between the center of the end bolt and the end of the plate measured parallel to the load direction, p 1 is the distance between the centers of neighboring bolts measured parallel to the load direction, and d 0 is the diameter of the bolt hole. to be included on top of the head. Supplied to DIN 603. Manufactured with a fully threaded shank. Nuts of fasteners have the standard coarse pitch unless otherwise stated. A coarse pitch M6 bolt or screw a countersunk hole providing a flush, snag free fit. These items are always fully threaded. Conforms

Search

damage. UNBRAKO® branded and manufactured to be stronger than the other size for size high tensile versions. drive permits a greater torque load to be applied to the joint over most other drive types. Please note providing a flush, snag free fit. The head diameter is slightly larger than that of the equivalent DIN A Machine screw with a phillips drive, designed to be tightened with a screwdriver. Typically found on For preloaded bolted connections which are slip-resistant at the Serviceability Limit State or the Ultimate Limit State the corresponding shear load F v,Ed should not exceed the design slip resistance as specified in EN1993-1-8 §3.9 and Table 3.2. Only bolt assemblies of classes 8.8 and 10.9 may be used as preloaded bolts.